New Bi-Phase Rate; Trade Swapping; Software Write Protect - Akai DR16 Operator's Manual

New Bi-phase Rate

The DR16 can receive and generate bi-phase signal of 23.976Hz (24fps, NTSC 0.1% pull-down). This
signal is used for synchronization in the film industry.
1) Press the SUB-MENU key.
2) Press the SYNC key.
3) Use the jog wheel to select
4) Use the jog wheel to select
Note: You will need an optional bi-phase interface board IB-806B to use this function.

Trade Swapping

The DR16 can select a set of 8-tracks (1–8 tracks or 9–16 tracks) assigned to route to the digital output of
an optional multi-channel digital interface board (IB-804A-ADAT interface board, IB-D8TIF-TASCAM
digital interface board. IB-D8MA-8channel AES/EBU digital interface board).
1) Press the SUB MENU key.
2) Press the MIX key.
3) Use the jog wheel to select
4) Press the STORE/ENT key.
5) Use the jog wheel to select either
6) Press the STORE/ENT key.

Software Write Protect

The DR16 can set the software write protect on the connected disks to protect them against the accidental
write to the disk operation.
1) Press the SUB MENU key.
2) Press the numeric key "1/DISK".
3) Use the jog wheel to select
4) Press the STORE/ENT key,
5) Use the jog wheel to set the Software Protect function to on or off.
6) Press the STORE/ENT key.
BIPHASE
and press the STORE/ENT key.
SMPTE23. 9 8F
and press the STORE/ENT key.
8-AES
.
NORM
for 1–8 tracks or
PROTECT
.
PROT OFF
appears on the display.
DR16 Addendum
SWAP
for 9–16 tracks.
5
Version 2.3