Installing With Single-Tuner Receivers And Software-Upgraded Dual-Tuner Receivers - EchoStar DISH Pro Plus Twin LNBF Installation Instructions Manual

Installing with Single-Tuner Receivers and Software-Upgraded
Dual-Tuner Receivers
The following instructions describe how to install the DISH Pro Plus Twin LNBF on a DISH 500 antenna
with DISH Pro and Legacy single-tuner receivers and with DISH Pro Plus dual-tuner receivers that have
upgraded software, as shown in Table 1. For dual-tuner receivers that do not have upgraded software, you
must instead use the instructions in Installing with any Dual-Tuner Receiver starting on page 8.
Table 1. Software Required for Dual-Tuner Receiver Installation
Receiver
DISH 322
DISH Player-DVR 522
DISH 721
DISH Player-DVR 921
Future DISH Pro Plus Dual-Tuner Receivers
Installation Instructions
Use the steps below while referring to Figure 6 on page 7 for this installation.
Locate and install the DISH 500 antenna using the instructions that came with the dish or
satellite receiver.
Run RG-6 coaxial cables from the receiver location(s) to the DISH 500 antenna using Table 2
and the notes that follow:
Receiver to Install
DISH Pro Plus DISH Pro
Dual-Tuner Single-Tuner
Receivers Receivers
1
1
2
1
1
a. Install a DISH Pro single-tuner or DISH Pro Plus dual-tuner receiver first.
Table 2. Receiver Installation Options
Legacy
Single-Tuner
Receivers
1
a
1
1
2
1 a
1
b
2
Software Version
L054 or later or current download
L059 or later or current download
Supported with a future version of
software
L052 or later or current download
All
Component Requirements
DISH Pro Plus Cables to DISH
Separator Pro Plus Twin
No 2
Yes 1
Yes 2
Yes 2
Yes 2
No 1
No 2
No 2
No 2
Supports 119W/ Supports additional
110W Compatible LNBF
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes No
Page 3