Specifications; Rack Mounting Instructions - Kustom GROOVE 1200 Owner's Manual

Input Impedance
Output Power
Frequency Response
Hum & Noise
System Gain
All measurements taken with 1 KHz
input signal, Tone controls flat, Gain and
Volume Maximum. Measured at effects
send output jacks on rear unless noted.
Amplifier Type
Footswitch
Power Requirements
Dimensions
The GROOVE 1200 was designed to mount into a standard 2-space rack. When mounting, use 4
screws to secure the amplifier to the rack. When using only one amplifier, use the bottom 2 spaces in the rack.
However, if more than one amplifier is used, leave one space open between the amplifiers to ensure proper
ventilation (shown below).
GROOVE 1200

Specifications

200K Ohm
450 Watts 8 Ohms @ 5% THD
750 Watts 4 Ohms @ 5% THD
1200 Watts 2 Ohms @ 5% THD
Actual response is tailored to speakers for accurate acoustical
20HZ-20kHz
response using a bass guitar as input.
-60db Residual Noise, all level controls 0% (minimum)
27db Preamp output
15db Preamp output, Active
25db Tuner output
27db Direct output
32db Power amp gain
Class B Descrete device Class B amplifier
Any non-momentary two-button foot switch can be used.
Use any standard tip-ring-sleeve cable
USA/Canada 120VAC/60Hz, 1500W nominal
Europe 230VAC/50Hz, 1500W nominal
UK 230VAC/50Hz, 1500W nominal
Australia 240VAC/50Hz, 1500W nominal
Japan 100VAC/50-60Hz, 1500W nominal
mm/kg 89 (Height) x 483 (Width) x 390 (Depth), 14 kg
Inches/Pounds 3.5 (Height) x 19 (Width) x 15.5 (Depth), 31 lbs

Rack Mounting Instructions

9