Makita DTD134 Instruction Manual page 7

LED indicator status
012023
NOTE:
Before checking the remaining battery capacity, be
•
sure to stop the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only bits that has inserting portion shown in the
figure.
For tool with shallow bit hole
Use only these type of bit. Follow the
A=12mm
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
Remaining battery capacity
About 50% or more
About 20% - 50%
About less than 20%
For tool with deep bit hole
A=17mm
To install these types of bits, follow
the procedure (1).
B=14mm
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
011405
1. To install the bit, pull the sleeve and insert the bit
into the sleeve as far as it will go.
1
2
012063
2. To install the bit, insert the bit-piece and bit into
the sleeve as far as it will go. The bit-piece should
be inserted into the sleeve with its pointed end
facing in. Then release the sleeve to secure the
bit.
2
1
012013
To remove the bit, pull the sleeve and pull the bit out.
NOTE:
For all countries other than Europe, it's not
•
necessary to pull the sleeve when installing the bit.
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as for as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
7
1. Bit
2. Sleeve
1. Bit-piece
2. Bit