Advertisement
Care
Machine housing, control panel
- Wipe with a soft, damp cloth.
- Do not use abrasive detergents.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ...
... if it contains detergent or fabric softener residue.
1.
Pull out, depress insert, completely remove.
2.
Open the cover.
3.
Clean with water and dry.
4.
Close and lock the cover (place cylinder on guide pin).
5.
Insert detergent drawer.
Leave detergent drawer open so that residual water can evaporate.
Drum
Leave washing machine door open so that the drum can dry out.
Rust stains use chlorine free cleaning agent, not steel wool.
Descaling
Descale according to the instructions of the descaling agent manufacturer, not required for
correct detergent dosage.
Information to indicator lights
Close the washing
machine door pro
perly; washing
may be caught.
Motor fault. Call customer service!
Downloaded From WashingMachine-Manual.com Manuals
7
Risk of electric shock!
Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Detergent solution pump
Set programme selector to Off, pull out the mains plug.
1.
Open and remove service flap.
For models with drainage hose:
2.
Take drainage hose out of the holder and pull out of the
housing. Remove sealing cap, allow detergent solution
to flow out.
Press on sealing cap and insert drainage hose into the
holder.
For models without drainage hose:
2* Carefully unscrew pump cover until the detergent solution begins to run out.
When the service flap is half full,
screw back the pump cover and empty the service flap.
Repeat steps until all the detergent solution has run out.
3.
Carefully unscrew the pump cover (residual water).
4.
Clean the interior, pump cover thread and pump housing (fan impeller in the
detergent solution pump must rotate).
5.
Reinsert and screw on pump cover.
6.
Insert and close service flap.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and select the Drain b programme.
Filters in the water supply
No washing in the machine!
Risk of electric shock! Do not immerse Aqua Stop safety device in water
Release water pressure in the supply hose:
1.
Turn off the tap!
depending on model
2.
Select any programme (except Spin B/Drain b).
Press Start M. Leave programme for approx. 40 seconds.
3.
4.
Set programme selector to Off.
Clean detergent so
Turn on the tap, supply hose
5.
Remove hose from tap.
lution pump (pa
kinked/jammed;
6.
Clean filter with small brush.
ge 9), outlet pipe/
clean filter (page 9), water
7.
Depending on the model, remove hose from the rear
drainage hose
pressure too low.
of the appliance and clean the filter.
blocked.
Water in the base pan, appliance lea
8.
Connect the hose and check for leaks.
king. Call customer service!
8
Risk of scalding!
What to do if ...
Allow detergent solution to cool down!
Turn off the tap!
F
Water is running out.
- Correctly attach/replace drainage hose.
- Tighten screw fitting on the supply hose.
- Start M not selected?
F
Water not flowing in.
Detergent not washed in.
- Tap not open?
- Filter blocked? Clean filter (page 9).
- Supply hose kinked or jammed?
F
Washing machine door
- Safety function active. Wait 2 minutes
cannot be opened.
- Rinse Hold selected?
F
Programme does not start.
- Start M selected?
- Door closed?
F
Detergent solution is not
- Clean detergent solution pump (page 9).
drained.
- Clean outlet pipe and/or drainage hose.
F
Washing not spun correctly.
- Distribute small and large items of washing in the drum.
F
Spin cycle actuated several
- Not a fault - unbalanced load detection system adjusts
times.
imbalance.
F
Water not visible in the drum. - Not a fault - water below the visible area.
F
Residual water in the
- Not a fault effect of the care product not impaired.
dispenser for care product.
F
Odour formation in the
- Run Cottons Æ 90 ºC programme without washing.
washing machine.
Use standard detergent.
F
Foam is coming out of the
- Too much detergent used?
detergent drawer.
Mix 1 tablespoon of fabric conditioner with ½ litre of water
and pour into dispenser II in the detergent drawer.
- Reduce detergent dosage for the next wash cycle.
F
Vibrations during spin cycle.
- Appliance feet fixed?
Secure appliance feet (Installation instructions).
- Transportation safety devices removed?
Remove transportation safety devices (Installation
(contains electric valve).
instructions).
F
Spin result not satisfactory.
- Reduced Ironing e selected (page 5)?
F
Display panel/indicator lights
- Power failure?
do not function while the
- Fuse tripped? Switch on/replace fuse.
appliance is running.
- If the fault occurs repeatedly, call customer service.
F
Programme progress longer
- Not a fault - unbalanced load detection system adjusts
than usual.
imbalance by repeatedly distributing the washing.
- Foam detection system active - a rinse cycle is started.
F
Detergent residue on the
- Occasionally phosphate free detergents contain
washing.
water insoluble residue.
- Select áFreshen Up/Rinse or brush the laundry after
washing.
F
If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
9
- Turn off the tap and call customer service (Installation instructions).
Safety instructions
- Read and follow the operating and installation instructions and all other information enclosed
with the washing machine.
- Retain documents for subsequent use.
Risk of electric shock
- Never pull out the mains plug by tugging the power cord!
- Never insert/pull out the mains plug with damp hands.
Risk of injury
- Washing machine door may become very hot.
- Caution when draining hot detergent solution.
- Do not climb on the washing machine.
- Do not lean on the open washing machine door.
- Do not touch the drum if it is still rotating.
Risk of posioning
- Keep detergents and care products out of the reach of children.
Risk of suffocation
- Keep packaging, plastic film and packaging parts out of the reach
of children.
Danger to life
On redundant appliances:
- Pull out the mains plug.
- Sever the power cord and discard together with the plug.
- Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and suffocating.
Risk of explosion
- Caused by detergents containing solvents, e.g. stain
remover/items of washing pretreated with solvent naphtha may
result in an explosion after being loaded into the washing machine.
Beforehand thoroughly rinse items of washing by hand.
Consumption values
Programme
Additonal
Load
Current **
Water **
Programme
function
duration **
Cottons Æ 40 ºC*
Wash Plus X
7 kg
0.65 kWh
65 l
2:30 h
Cottons Æ 60 ºC
-
7 kg
1.20 kWh
70 l
1:35 h
Cottons Æ
Wash Plus X
7 kg
1.19 kWh
49 l
2:36 h
Stains ã 60 ºC*
Cottons Æ 90 ºC*
Wash Plus X
7 kg
2.00 kWh
75 l
2:33 h
Easy Care A 40 ºC*
Wash Plus X
3 kg
0.55 kWh
50 l
1:24 h
Easy Care A 40 ºC
(also suitable as Short
-
3 kg
0.55 kWh
40 l
0:55 h
programme)
à Mixed Load
-
3 kg
0.60 kWh
37 l
0:50 h
Delicates 30 ºC
-
2 kg
0.25 kWh
34 l
0:32 h
Woollens u 30 ºC
-
2 kg
0.15 kWh
30 l
0:40 h
* Programme setting with Wash PlusX option and maximum spin speed for testing according to
or in accordance with EN 60 456 and IEC 60 456.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
detergent, fluctuations in the mains voltage and selected additional functions.
10
11
Washing machine
en
Operating instructions
Read these instructions before switching on the washing machine!
Also follow the separate Installation instructions.
Follow the safety instructions on page 11!
Advertisement
