Advertisement
1 KP~ without _vower supvlv
1 each:
preamplifier chassis
DC jumper cable (KBL to KPA)
"T" shaped Allen driver
Owner's Manual
1 KPA with ~ower su~pl_v
1 each:
preamplifier chassis
KPA power supply with AC and DC cables attached
DC jumper cable (KBL to KPA) *not used when the
dedicated KPA supply is used*
"T" shaped Allen driver
Owner's Manual
Inspect the unit(s) and power supply(s) for damage. If any is evident, or
some of the accessories
are missing, contact your dealer or the factory
immediately. If everything is in order you can proceed with the next steps.
D, IN/~TALLATION
1. Cautions
Note: These are important points of which you should always be aware.
They are presented before the actual installation
procedures, should you
not read through the Manual entirely.
a. When installing
the KBL always connect the DC cable between the
preamp chassis and the power supply before plugging the power supply
into the AC mains.
b. When installing
a KBL/KPA combination
~ connect
the DC
cables between the KPA and the KBL, and between the power supply
and the KBL before plugging the power supply into the AC mains.
c. ~ disconnect
the AC from the mains before
disconnecting
the
DC cable(s) from the preamp(s).
d. A single KPA cannot be operated in balanced mode. The "Balanced"
push-button should not be activated unless two KPA are used.
e. These points are true for both the initial
installation
of the KBL or
KPA and for revisions of your system that require their relocation.
Advertisement
