No Display Appears On Screen, Power-On Indicator Flashes - Fujitsu Siemens Computers Lifebook C Series Getting Started

C Series
The power adapter is not connected correctly.
Ê
Switch the notebook off.
Ê
Check whether the power adapter is connected correctly to the notebook.
Ê
Check whether the power cable is plugged properly into the power adapter and into the mains
outlet. The indicator on the power adapter should illuminate.
Ê
Switch the notebook on.
The notebook is prevented from booting by a disk in the floppy disk drive.
Ê
Check whether this floppy disk is a system disk. Remove the floppy disk.
Operating system files may be damaged or missing.
Ê
Boot the notebook with a system floppy disk, via the floppy disk drive.
The safety function indicator lights up.
Ê
Enter your password.
If you have forgotten your password, please contact our Hotline/Help Desk. No
!
guarantee claim can be made for this service.

No display appears on screen, power-on indicator flashes

If no display appears on the screen and the power-on indicator
following causes:
The screen power-management feature may be active.
Ê
Press any key to activate the display.
The notebook is in Standby or Suspend mode.
Ê
Press the Suspend/Resume button to end the Standby or Suspend mode.
The display angle or brightness may not be properly adjusted.
Ê
Change the display angle and set the brightness by pressing the key [Fn] together with the key
[F6] (darker) or [F7] (brighter) until the picture appears correct.
The notebook is set so that the picture only appears on the external screen.
Ê
Press the key combination [Fn] + [F10] to switch over the display to the LCD screen or to
specify the simultaneous display on the LCD screen and the external screen.
10 - English
Downloaded from LpManual.com Manuals
flashes, this may have the
A26391-K110-Z100-2-7619