Table of Contents
Advertisement
KPS-20
BASIC
OPERATION
Below are instructions
for a quick installation
of the KPS-20. Please refer to
the Typical System Setup illustrations
on pages 24, 25, and 26. Also, allow the
unit to settle
at room temperature before operation is started.
1. Plug the KPS-20 into
the standard
wall AC receptacle.
Connect the KPS-20
output
to the appropriate
location:
KPS-20i to preamp input;
KPS-20i/I
to
amplifier
or crossover
input;
KPS-20t to D/A processor
input.
Engage the
power switch
on the rear
panel by pushing it up to the ON position.
This
powers the processor
sections
in the KPS-20i and KPS-20i/I.
2. Press the Power button on the front
panel or on the remote control
to power
the transport
stages.
The display
section
will now illuminate.
The processor
portion
of the KPS-20i and KPS-20i/I is on at all times once the rear panel
switch is engaged.
This is to insure
thermal
stability
and improve sonic
performance.
3. Press the Open/Close button
on the front
panel and the top cover assembly
will open, exposing the CD transport
and spindle.
Place the compact disc,
label side up, onto the drive spindle.
Place the five point custom clamp onto
the drive spindle,
securing
the CD in place.
Make sure the clamp is centered
firmly on the custom CD spindle
hub. Press the Open/Close button again or
Play and the cover will close.
NOTE: In the event
that
you wish to rapidly
change a number of CDs, the
KPS-20 can be played with the cover open. Move the switch on the back panel
marked "Manual~Auto"
to the "Manual" position..The
KPS-20 will
now play
with the cover open. However, do not forget
that
you are compromising the
quality
of the music when the CD is exposed to light.
Also,
it is always
preferable
to close the cover when playing music at a high volume in order to
maintain optimum tracking.
4. Press Play on the front
panel or remote control.
Note: if you pressed Play in
step 3 the disc will already be playing. The disc will start
playing from track 1.
To select
a 'different
track you can press the track forward {> I} or track back
{I <} button until
you reach the desired
track number or punch the number of
the desired track into the keypad on the front panel or rem'ote control.
5. Press the Stop button to stop play.
7
Hide quick links:
Advertisement
Table of Contents
