Table of Contents
Advertisement
1
Introduction
wake-on-lan
It is supported via the onboard LAN port or via a PCI LAN card
that uses the PCI PME (Power Management Event) signal. However,
if your system is in the Suspend mode, you can power-on the system
only through an IRQ or DMA interrupt.
wake-on-PS/2
tem.
rtc timer
and time.
ACPI STR
cation. ACPI has energy saving features that enables PCs to imple-
ment Power Management and Plug-and-Play with operating systems
that support OS Direct Power Management. ACPI when enabled in
the Power Management Setup will allow you to use the Suspend to
RAM function.
With the Suspend to RAM function enabled, you can power-off the
system at once by pressing the power button or selecting "Standby"
when you shut down without having to go through the sometimes
tiresome process of closing files, applications and operating system.
This is because the system is capable of storing all programs and
data files during the entire operating session into RAM (Random
12
This feature allows the network to remotely
wake up a Soft Power Down (Soft-Off) PC.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
This function allows you to use the PS/2 key-
board or PS/2 mouse to power-on the sys-
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
The RTC installed on the system board allows your
system to automatically power-on on the set date
The system board is designed to meet the ACPI
(Advanced Configuration and Power Interface) specifi-
Advertisement
Table of Contents
