Korg TRITON RACK Installation Manual page 3

TRITON RACK HD MANUAL
3.2 Connection of the Power Supply
It is natural that the Hard Disk needs a power supply; we use the power supply of the
floppy disk that causes no problems because access to hard disk and floppy is not at the
same time. Unplug of the two-wire floppy disk power cable and connect it to its mail con-
nector of the HD-Board. Connect the four-wire (red-black) cable of the hard disk connec-
tor to the mail power connector of the floppy disk.
4. First test and formatting of the Hard Drive:
Now it's time for a first check. Put the connector of the Flat cable that comes from the
Hard Disk Board to your Triton SCSI – Interface. Turn your Keyboard and switch it on.
Now you should hear the Hard Disk working.
Now go to the menu Disk and the Utility. You can format the Hard Disk now. You see the
Hard Disk as Unit 1. If you want you can assign the Hard Disk to another ID (See:
change of the SCSI-ID)
5. New Installation of the SCSI Boards:
5.1 New mounting of the metal angle of the SCSI-Board
Uninstall the SCSI-Board and remove the metal angle. Please install this metal angle on
the 25 female connector that comes from the Hard Disk-Board (See figure 1).
-2-