Connecting Jumper Cables; Warning Triangle; Jump Starting - BMW 328i Owner's Manual

Hide thumbs Also See for 328i:
Table of Contents

Advertisement

The first aid pouch is located on the right-hand
side of the cargo bay in a storage area.

Warning triangle*

The warning triangle is located on the left-hand
side of the cargo bay. Press the tab to take it
out.

Jump starting

If the car's own battery is flat, your BMW's
engine can be started by connecting two
jumper cables to another vehicle's battery. You
can also use the same method to help start
another vehicle. Only use jumper cables with
fully-insulated clamp handles.
Do not touch any electrically live parts
when the engine is running, or a fatal acci-
dent may occur. Carefully adhere to the follow-
ing sequence, both to prevent damage to one or
both vehicles, and to guard against possible
personal
injuries.<
Preparation
1.
Check whether the battery of the other
vehicle has a voltage of 12 volts and
124
Online Edition for Part no. 01 41 0 012 865 - © 08/06 BMW AG
approximately the same capacitance in Ah.
This information can be found on the bat-
tery.
2.
Switch off the engine of the assisting vehi-
cle.
3.
Switch off any consumers in both vehicles.
There must not be any contact between
the bodies of the two vehicles, otherwise
there is a danger of
shorting.<

Connecting jumper cables

Connect the jumper cables in the correct
order, so that no sparks which could
cause injury
occur.<
Your BMW has a jump-starting connection in
the engine compartment which acts as the bat-
tery's positive terminal, refer also to the Engine
compartment overview on page 113. The cap is
marked with +.
1.
Pull the cap of the BMW jump-starting con-
nection up to remove.
2.
Attach one terminal clamp of the plus/+
jumper cable to the positive terminal of the
battery or a starting-aid terminal of the vehi-
cle providing assistance.
3.
Attach the second terminal clamp of the
plus/+ jumper cable to the positive terminal
of the battery or a starting-aid terminal of
the vehicle to be started.
4.
Attach one terminal clamp of the minus/–
jumper cable to the negative terminal of the
battery or to an engine or body ground of
the assisting vehicle.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

328xi335i

Table of Contents