Effects - Korg OASYS musical instruments Operation Manual

Vector and MIDI
The Vector features interact with MIDI in two different
ways: through the Vector Joystick, and through the
Vector CC Control.
The Vector Joystick sends and receives two MIDI
controllers: one for the X axis, and the other for the Y
axis. In Global mode, you can assign these to any MIDI
CC numbers you like. The defaults are CC#118 for the
X axis, and CC#119 for the Y axis.
Vector Synthesis System
Vector Joystick
Vector Joystick
MIDI In
scale
Vector EG

Effects

Effects are covered in their own section of the manuals,
so we won't go into too much detail here.
Insert Effects
Insert Effects let you send either individual Oscillators
or the entire Program through up to 12 effects, in
series. You can use any type of effects, from distortions
and compressors to choruses and reverbs. The Insert
Effects can be routed to the main outputs, or to any of
the individual outputs.
For more information, see "Insert effects" on page 185.
Master Effects
There are two Master Effects, which are accessed
through Sends 1 and 2. These are best-suited to effects
such as reverbs and delays, but you can use them with
any type of effect.
For more information, see "Master effects" on
page 186.
The Vector Joystick and its CCs control the Vector
position, in conjunction with the Vector EG.
The Vector CC Control, on the other hand, is generated
by the Vector position. Normally, this will only affect
internal sounds and effects. If you like, however, you
can also enable a Global parameter to send these
generated CCs to external MIDI devices.
For more information on Vector Synthesis, see "1–5:
Vector Control" on page 38 of the Parameter Guide.
Vector CC MIDI Output
Global Controllers
MIDI CC Assignments
Defaults: X=118, Y=119
Vector CC Control
X+/– and Y+/–
VJS X and Y modes
CC Assignments
Vector Volume Control
Osc 1/2 Center Volume
and Equal Power settings
Total Effects
The two Total Effects are dedicated to processing the
main L/R outputs. They're ideally suited to overall
mix effects, such as compression, limiting, and EQ–but
as with the other effects sections, you can use any type
of effect that you like.
For more information, see "Program P9: Master/Total
Effect" on page 134 of the Parameter Guide.
Global switch:
Vector MIDI Out
Vector Joystick
Vector CC Control
Vector CC Modulation of
Program and FX Parameters
Program switch:
Enable CC control
Program switch:
Enable Volume control
Effects
Vector CC MIDI Output
Vector Modulation of
Oscillator Volume
65