Trouble-Shooting Guide - LG WD-8050F Service Manual

Trouble - Shooting guide
Check the following before asking for service if the error massage is displayed during
washing, rinsing or spinning.
Request for the service center or agent in the case of failure or damage except for the followings.
Symptom Check points
• Is the water tap turned off ?
• Is the water frozen?
• Is the water pressure low or the
filter clogged ?
• Is the laundry tilted to one side
in the drum?
• Is the washer leveled ?
• Is there foreign material in the
drain pump ?
• Is the drain hose bent or higher
than 85cm above the floor ?
• Is the hose clogged ?
• Is the hose frozen ?
Door is faulty
• Did you run the washer while
the
door is not closed completely?
Water is not heating
14
P/No.3828ER3001M P/No.3828ER3001M
Solution
• Turn the water tap on.
• Melt it with 50°C hot water.
13
Refer
• Disconnect the inlet hose
and clean the filter.
12
Refer
• Spread the laundry evenly.
• Release imbalance by pressing
the [Start/Pause] button. If it
happens after rinsing or spin-
ning, call for service.
• Install it on a film and even
floor.
• Clean and remove foreign
material from drain filter.
• Put the drain hose evenly.
• Place the drain hose under
85cm from the floor.
• Melt it with 50°C hot water.
• Close the door.
If it is not released, call for
service.
• Unplug the power plug and
call for service.
Symptom Check points
It is displayed when the water pressure
sensor malfunction.
It is displayed when the water overfills due to abnor-
mal water inlet valve.
The machine
• Did you press the power button.
does not
start up.
• Is the power plug unplugged?
• Is the power supply correct?
• Is the short-circuit breaker turned
off?
Excessive suds
• Did you use more detergent than
recommended?
• Did you use low suds detergent for
the front loading washing machine?
Excessive
• Did you remove the transit bolts?
vibration and
noise. • Is the washer levelled?
• Is the drain pump clogged with
foreign material?
• Is the washer loaded with excessive
clothes?
Solution
• Close the water tap.
• Take out power plug.
• Call the service center.
• Turn it on.
• Plug it to power supply.
• Use exclusive AC220 – 240V
outlet with ground terminal.
• Turn it on.
• Put the recommended
amount.
• Use detergents only for front
loading washing machine.
• Remove it.
• Place it on an even floor.
• Remove foreign material from
the drain pump.
12
Refer
• Remove the excessive loads.
15
P/No.3828ER3001M