Table of Contents
Advertisement
Taking Pictures
1. Switch on the power by sliding the Power Switch to the side,
Safety Notes
holding it for 1 second, and letting it go.
2. Set the Mode Dial at Shooting Mode
capture or Movie Clip Mode
(
3. If you would like to capture a still image, please set the focus
switch at correct focus range which are:
Macro (
): 0.18m~0.25m
Portrait (
): 0.8m~1.3m
Normal (
): 1.3m~infinity
4. Set up all the preferred features and functions.
5. Hold still and press the Shutter Button.
6. The LED Indicator will start blinking after the Shutter Button
is released. After the LED Indicator stops blinking, then you
are able to take another shot.
Note
The TFT LCD Monitor will show "Low Light!" as a warning to
remind you that the image that you are going to capture is under
a low light environment. It is suggested to set the Flash Mode at
Auto Flash or Fill-in Flash for supplementary light to compose a
good image.
30
(
)
for still image
)
for videos.
Playback / Erasing
Viewing A Part Of An Image
Set the Mode Dial at Playback Mode
will show the latest captured image.
1. Press Right Direction Button (
2. Press Up Direction Button (
3. Press Right Direction Button (
4. Use four direction buttons to view the image.
5. Press Menu Button to cancel this function.
Showing The Information Of A Still Image
Please set the Mode Dial at Playback Mode
Monitor will show the latest capture image. Use Up
Down
(
)
Direction Buttons to select other captured images.
1. Select an image.
2. Press LCD Button to show the information.
3. Press LCD Button again to erase the information.
31
(
).
The TFT LCD Monitor
).
) to adjust the size of the image.
) again to enter.
(
)
. The TFT LCD
(
)
and
Advertisement
Table of Contents
