Din Interconnect Cable; Input Mode Switch - Rockford Fosgate Power 360 Installation Manual

DIN INTERCONNECT
The 5-pin DIN cable provided connect the Amp to its equalizer/
preamplifier. Run this cable away from the main power wire
(white 10-Gauge)
cable. Cable color code and pin configuration are given below:
Shield - Ground
Red - +18 Volts
Black - -18 Volts
White - Right Channel Signal+
Green - Left Channel Signal +
(or yellow)

INPUT MODE SWITCH

The input of the Power 650 and Power 360 normally comes from
the DIN input connector and is split by the crossovers into high
and low channel drives. However, there are some cases where it
is desirable to be able to drive the low channels independently.
For instance, if one wanted to drive the system as two
completely independent stereo amplifiers, one would need to
drive the high channel pair with one stereo signal pair, and the
low channel
The input mode switch (located near the crossover controls on
the units front panel) switches the low channel inputs over the
RCA female
in the circuit and can be used as usual.
CABLE
to prevent noise from being coupled into the
Female or pre-out Connector
with another.
connectors.
Ground-
Power Amplifier
The low-frequency
-14-
crossover remains