Advertisement
SAFETY INFORMATION
WARNING : THIS APPLIANCE MUST BE EARTHED
IMPORTANT
T
he wires in the mains lead are coloured in accordance with the following code:
Green and yellow:
Earth (E)
Blue:
Neutral (N)
Brown:
Live (L)
As the colours of the wires in the mains lead of the apparatus may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal which is marked by the letter E
or by the safty earth symbol or coloured green and yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured red.
If a 13 Amp (BS1363) plug or other type of plug is used, a 5 Amp fuse must be fitted either in the plug or at
the distribution board.
GENERAL INSTALLATION
1
DO NOT expose the unit to rain or moisture. If any fluids of foreign objects
should enter the unit, disconnect the power plug immediately.
2
DO NOT run microphone cables near mains, data, telephone or 100V lines.
3
PROTECT the unit from heat and allow adequate ventilation. Place away from
direct source of heat, such as heating vents and radiators.
4
AVOID jointing the microphone cables, when this is unavoidable make sure a
good screen connector is used.
5
ALWAYS use a balanced or floating low impedance microphone terminating
in balanced input on long microphone runs.
GENERAL DESCRIPTION
ADS 1030 MIXER AMPLIFIER
The 30 watt RMS amplifier can be used on Mains only.
The amplifier has two unbalanced microphone inputs and two auxiliary inputs for
background music sources. Amplifier controls are located on the front panel.
SPECIFICATIONS
RMSOutput power
Constant Voltage output
Constant Impedance output
Distorsion at rated power
Frequency responce
Tone Control range
Microphone Input
Sensitivity / Imp
S/N ratio
Auxiliary Input
Sensitivity
S/N ratio
Operating Conditions
Mains power supply
DC power supply
Dimensions (HWD)
Weight
30 Watts into 8 ohm at 1 kHz
100V
4 - 16 ohm
< 1% THD
100Hz to 18kHz
+ or - 3db
Bass
+ or - 10db
Treble
+ or - 10db
-65db
+ or - 2db / 600ohm
- 55db
+ or - 2db
- 20db
+ or - 2db
>55db
240V AC at 50 Hz
83 x 320 x 230
4 kg
Advertisement
