Removing The Front Leg Cover; Normal Operation; Refrigerator Doors - Samsung SRS676GDHLS User Manual

To Refi t The Ice Bucket
- Assemble it in the reverse order
of disassembly.
- Push the bucket in firmly until
you hear a clicking sound.
- When the bucket does not fit
into its place, turn the gear
handle on its back by 90
degrees and reinstall it again as
shown in figure 2.

Normal Operation

- Any sounds you hear when
the ice maker dumps ice into
the bucket are part of normal
operation.
- Not dispensing ice for long
periods may cause ice clumps
in the ice bucket. Remove the
remaining ice and empty the
bucket.
- When ice does not come out,
check for any ice stuck in the
chute and remove it.
- The first batch of ice cubes may be small due
to air in the pipe after connection, any air will be
purged during normal use.
- When ICE OFF blinks on the display panel,
CAUTION reinsert the bucket and/or make sure it's
installed properly.
- When the door is open, the Ice and water
dispenser do not work.
- If you close the door hard, it may cause water
spilling over the ice maker.
- To prevent dropping the ice bucket, use both
hands when removing it.
- To prevent injury, be sure to clean up any ice or
water that may have dropped on the floor.
- Do not let the children hang on the ice dispenser
or on the bucket. They may get hurt.
- Be sure not to put your hand or any object into the
ice chute. It may cause personal injury or damage
mechanical parts.
SETTING UP THE

REFRIGERATOR DOORS

If your entrance won't allow the refrigerator to pass
easily through it, you can remove the doors.
DA99-01745A-27.indd 07 DA99-01745A-27.indd 07

Removing the Front Leg Cover

First, open both the freezer and refrigerator doors,
and then take off the front leg cover by turning the
three screws counter-clockwise.
Figure2 Figure2
Separating the Water Supply Line
from the Refrigerator (Optional)
1. Remove two water lines (gray one is for ice and
the other one is for water) by pressing the coupler
and pulling the water line
1
Ice Chute Ice Chute
Be careful that the water tube match same
color.
Reattaching the Water Supply Line
1. The Water Line must be fully Inserted to the center
of transparent coupler to prevent water leakage
from the dispenser.
away.
2
1
2
center of transparent coupler center of transparent coupler
setting up _07 setting up _07
14. 7. 17. 14. 7. 17. 11:35 11:35