Installation - ViewSonic N3735w User Manual

Installation

1. Insert Remote Control Batteries
1 Remove the battery cover by pulling then lifting the knob on the cover.
2 Insert the batteries, corresponding to the (+) and (-) markings on the battery compartment.
3 Reattach the battery cover.
CAUTION
Only use the specified AAA batteries.
•
Do not mix new and old batteries. This may result in cracking or leakage,
•
which may pose a risk of fire or lead to personal injury.
Insert batteries according to (+) and (-) markings. Inserting the batteries
•
incorrectly may result in cracking or leakage, which may pose a risk of fire or
lead to personal injury.
Dispose of the battery in accordance with local laws and regulations.
•
Keep the battery away from children and pets.
•
When the remote control will not to be used for an extended period, remove
•
the batteries.
2. Connecting RF antenna and Cable TV
Make sure the power is OFF before installing your LCD TV.
1) AIR TV: Connect the LCD TV to TV antenna with 75-ohm coaxial cable. Preset
the air TV channels into memory with Auto Scan function when using an antenna
TV system. This air input jack both support TV and DTV systems. Besides, the TV
system (NTSC) and DTV system (ATSC) can be found by the scanning of "AIR"
in the Auto Scan function. See page 23.
2) Cable TV: Connect the LCD TV to the cable with CATV and Digital cable. Preset
the cable TV channels into memory with Auto Scan function when using a cable
TV system. The cable input jack both support CATV and Digital cable systems.
Besides, the CATV system (cable TV) and Digital cable system (clear QAM) can
be found by the scanning of "Cable" in the Auto Scan function. See page 23.
Note: Users can select either Air or Cable TV cable to be connected to the TV/DTV
IN jack. To watch both of them, use an adapter to connect both Air and Cable
cables to the jack.
ViewSonic
11
N3735w