What to do if...
System characteristics
What to do if...?
... the heating system will
not start
... burner does not start
or starts irregularly
... burner is not started;
fault indicator " " appears
on display
burner is switched off
even though rooms are
not yet at the required
temperature
14
Cause
No mains voltage
Rotary selector "
" is
set to "0".
Fuse in the power distri-
bution panel (domestic
mains fuse) or if the con-
trol unit has blown
No gas available
Control unit fault
False start
Low water
Fault in the combustion
air supply or flue gas
system
Heating water tempera-
ture or required room
temperature are set too
low
Air in the heating system Bleed radiators
Remedy
Switch the ON/OFF
switch ON
Setting the required heat-
ing water temperature
(see page 11)
Notify your heating con-
tractor
Open the gas shut-off
valve and if necessary
check with your gas sup-
plier
Check the fault code on
the display. Notify your
heating contractor of the
fault code.
Reset burner fault (see
page 6); if this attempt to
start also fails, notify your
heating contractor.
Notify your heating con-
tractor.
Notify your heating con-
tractor
Raise the heating water
temperature with rotary
selector "
" (see
page 11) or raise required
room temperature (see
remote control operating
instructions)