Stopping/Restarting Your Dryer - Whirlpool Easy Clean 100 Series Use And Care Manual

3. Turn the Cycle Control Knob to the
desired cycle. Use the Energy
Preferred Automatic Setting (*)
to dry most loads (see page 8).
4. Set the Temperature Selector to the
desired setting. Refer to drying
cycles charts on pages 1 O-l 2.
5. Push the Start Button.
NOTES:
l
Your dryer stops automatically when a
cycle ends.
l
Higher air flow from your new dryer may
blow out accumulated lint from the existing
exhaust system.
Stopping/restarting your dryer
You can stop your dryer anytime during a cycle.
To stop the dryer, elther:
To restart the dryer:
l
Open the dryer door.
1.
Close the door.
2. Select a new cycle and temperature
(if desired).
3. Push the Start Button.
OR
l
Turn the Cycle Control Knob
to Off.
NOTE: The Cycle Control Knob
should point to an Off area
when the dryer is not in use.