Attaching Accessories - Victoria E-2073 Operating Instructions Manual

12
e) Threading with 2 needles
If you have inserted the twin needle, as
described in Chapter 8:
• Pull out both roll pins and put on
two spools of thread.
You can put a felt pad under the
spool of thread, to protect the
machine casing.
• Pass the two upper threads through,
just as you would for a single thread,
...
until the threads are at the needle:
but in this case, thread the two ends
of the upper threads separately
through the two needle eyes.
• The lower thread is also passed
through and collected in the same
way as for the single thread.

8. Attaching accessories

Warning!:
First pull the power plug out of the
power socket! This will prevent the
machine from being started unintention-
ally while you are working.
a) Changing needles
First raise the needle fully, by turning
the handwheel.
Loosen the clamping screw and
take out the old needle.
Insert the new needle, with the flat
end towards the rear. Insert it up to
the top
and turn the clamping screw to lock
it in place.