Connecting The Sonicwall Cdp Appliance To Your Network; Sonicwall Cdp Software Interfaces - SonicWALL CDP 3440i Getting Started Manual

Connecting The SonicWALL CDP Appliance to Your Network

Your SonicWALL CDP appliance is designed to operate in most network setups with
minimal configuration. The following instructions guide you through the process of
connecting the SonicWALL CDP appliance to your network.
1. Plug one end of the provided Ethernet cable into the LAN port on the back of your
SonicWALL CDP appliance.
2. Plug the other end of the cable into an open port on your network hub or switch.
3. Plug the supplied power cable into the back of the SonicWALL CDP appliance.
4. Plug the other end of the supplied power cable into an AC socket. The SonicWALL
CDP appliance automatically powers on and begins the initial boot process.
Note:
The boot process may take several minutes to complete when powering on the
SonicWALL CDP appliance for the first time.

SonicWALL CDP Software Interfaces

Upon installation, the CDP software provides the user with the following two interfaces:
SonicWALL CDP Enterprise Manager - This application provides the system
administrator the ability to configure reporting, alarms, data recovery and to create and
apply policies for SonicWALL CDP agent computers.
SonicWALL CDP Agent Tool - This application provides individual users the ability to
connect to the SonicWALL CDP appliance. It provides configuration, status, monitoring
and file, and disaster recovery for that machine, End-users can recover file versions
through a simple user interface.
SonicWALL CDP 3440i/4440i Getting Started Guide Page 15