Table of Contents
Advertisement
5-2. Front PCB
1) FR-5101NT, 5401NT
Check after repair
1. In assem bling F-P C B , use only specified screw s.
2. C heck if button operation after reassem bling.
3. There should be no gap betw een F -C ontrol panel
and F reezer door.
4. U se sm all size screw M 5 x L15, w hen the screw
is over-spinned.
5. If the adhesive of F-C ontrol panel nam e plate is
w eak, change the plate for a new one.
5-3. Freezer Louver
1) FR-5101NT, 5401NT
T he louver hook w hich has been backside of the
louver w ill be disassem bled, if inset a screw driver
into the chilly draft blow ing outlet and pull the louver.
Check after repair
1. Insert the bottom part of louver into the groove
w hich is located at rear bottom part of freezing room .
2. A ssem ble louver com pletely but there should not be
dam aged the hook.
5-4. Freezer Sensor
1) FR-5101NT, 5401NT
R em ove the alum inum tape from louver insulator.
Take off the freezer sensor.
Louver Insulator
F Sensor Fixture
SCREW
(T2 PEN 4 8 MFZN)
PANEL *F CONTL
(T2 FLT 4 12 MFZN)
Aluminum Tape
16
PCB *F AS
SCREW
FCP
Advertisement
Table of Contents
