ViewSonic PJ1158-1 Service Manual page 21

Can't communicate with computer
via NETWORK terminal.
Does the Lamp
on lower right of the
Network connector light
in green?
Are
both IP Address
and Subnet mask in the
Network > Information menu set to
"0.0.0.0" after waiting more than
1 minute?
Is
the DHCP in the
Advanced Menu > Network
> DHCP is on?
Set IP address and Subnet Mask
in the Advanced Menu > Network
> IP ADORESS and > SUBNETMASK
menu with manual operation.
ViewSonic Corporation
Check at operating mode
NO
YES
the Network > Information menu
NO
YES
YES
NO
Is the computer
connected with the
projector directly?
YES
Is IP Address in
set to "0.0.0.0" after waiting
more than 1 minute?
YES
Are there
any damage to the cable
between computer and
projector?
YES
Use new LAN cable
If
Subnet Mask is
"255.255.255.0", are
"xxx.yyy.zzz" portion of IP address
setting of computer and
projector
same?
IP address: xxx.yyy.zzz.N
YES
PWB assembly MAIN
Is there
DHCP server on
the network which the
projector is connected
to?
NO
Set IP address and Subnet
Mask in the
NETWORK menu with manual
operation.
18
Confidential - Do Not Copy
NO
Make sure NETWORK
hardware
NO
PWB assembly NETWORK
NO
PWB assembly NETWORK
PWB assembly MAIN
Use the same IP address
NO
setting except for "N" on
computer and projector.
PWB assembly NETWORK
YES Make sure those settings
of the projector and
computer are correct.
PJ1158-1