Sealing The Film - Bifinett KH 1605 Operating Instructions Manual

Slide the cutter
q
to the other side.
Note:
The film will only be cut when you slide the cutter
from left to right!

Sealing the film

Attention:
For sealing use only films made of PE-HD (Polyethy-
lene of high density). Otherwise, the sealing seam
will not be tight and the appliance could be damaged.
You can recognise films of this type by the inscription
"PE-HD" on the packaging.
Attention:
Do not heat the supplied film, for example in a water-
bath or similar. It is construed for temperatures of
a maximum of 60°C.
Press simultaneously on the two unlocking
devices left and right
a
appliance cover
u
Lay the end of the film tube to be sealed over
the sealing wire
t
Place the selector switch
"Seal".
Then close the appliance cover
the film tube does not slip off of the sealing
wire .
t
Press down the appliance cover
sides until it audibly clicks in at left and right.
over the film and all the way
and open up the
i
.
.
into the position
h
. Ensure that
u
on the outer
u
Press and hold the broad button
hands until the control lamp
the button pressed down until the control lamp
goes out.
q
Note:
To achieve the best results, press the button
continuously, applying an even pressure
and using both hands.
Warning:
If the control lamp
of 10 seconds, the appliance is defective! Immediately
remove the plug from the wall socket. Do not attempt to
repair the appliance yourself. In this case, contact
Customer Services.
Re-open the appliance cover
above, and remove the film. This is now sealed
at one end to a bag. This bag can now be filled
and the other end sealed by the same proce-
dure.
Warning:
Fill the bags in such a way that, under no circum-
stances, food remnants or fluids can run out of the
bag when sealing it and permeate into the appliance.
- 4 -
o
lights up. Hold
y
does not go out after a maximum
y
, as described
u
with both
down
o