Jumpers Setup; Connectors - ASROCK K7VT2 User Manual

2.7 Jumpers Setup

2.7 Jumpers Setup 2.7 Jumpers Setup
2.7 Jumpers Setup 2.7 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed
on pins, the jumper is "SHORT". If no
jumper cap is placed on the pins, the
jumper is "OPEN". The illustration
shows a 3-pin jumper whose pin1 and
pin2 are "SHORT".
Jumper
FSB_SEL1
(see p.6 item 23)
PS2_USB_PWR1
(see p.6 item 26)
CLRCMOS
(see p.6 item 17)

2.8 Connectors

2.8 Connectors
2.8 Connectors 2.8 Connectors 2.8 Connectors
Connectors are NOT jumpers. DO NOT place jumper
caps over these connectors.
Connector
FDD connector
(34-1 pin floppy)
(see p.6 item 10)
Note: Match the red marking on the floppy ribbon cable with Pin1
Primary IDE connector (Blue)
(see p.6 item 7)
IDE1
PIN1
Connect to the motherboard
Setting
FSB_SEL1
2_3
FSB 100 MHz
Note: Set CPU front side bus frequency
1 2
+5V
Note:requires 2 Amp and higher standby current
Solder points
Figure
FLOPPY1
Pin1
Blue
Blue
80 Pin ATA 100/133 cable
Description
FSB_SEL1
1_2
FSB 133 MHz
2 3
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
+5VSB
USB wake up events;
Disconnect the power cord ,
then short the solder points
to clear CMOS
Description
Red marking
Secondary IDE connector (Black)
(see p.6 item 8)
IDE2
PIN1
Black
Connect to the IDE devices
1 1 1 1 1 1
1 1 1 1