Inserting Batteries Into The Remote Control And Dvd Player - Silvercrest KH 6502 Operating Instructions Manual

Risk of fire!
• Do not use the appliance in the vicinity of hot surfaces.
• Do not locate the appliance in places exposed to direct sunlight, If you
do, it may overheat and become irreparably damaged.
• Do not leave the appliance unattended when in use.
• Never cover the ventilation slots of the appliance while it is being used.
• Do not place open fire sources, such as candles, on or near the device.
Injury hazard
• Keep children away from the connecting cable and the appliance. Children
frequently underestimate the dangers of electrical appliances.
• Ensure that the appliance stands with a safe and secure positioning.
• Do not operate the appliance if it has sustained a fall or is damaged.
Arrange for the appliance to be checked and/or repaired by qualified
technicians.
• Keep batteries away from children. Children can put batteries into their
mouths and swallow them.
Danger! Laser radiation!
The appliance is fitted with a „Class 1 Laser".
• Never open the device.
• Never attempt to repair the device.
• There is invisible laser radiation inside the device.
Do not expose yourself to the laser beam.
Note:
Some aggressive furniture finishes can have a destructive influence on
the device's rubber feet. If necessary, place the device on a nonslip pad.
Thunderstorms!
Equipment connected to a power supply can be damaged during a
thunderstorm. You should therefore always pull the power plug from the
power socket when there is a storm.
Notice regarding surge voltages
(FEO / fast electrical overloads):
In a case of malfunction due to an electrical fast transient (power surge)
the product must be returned to default settings in order to re-establish
normal operation. Possibly the power supply must be separated and then
reconnected. The batteries (if present) must be removed and then reinserted.
Notice regarding separation from mains-power
The FUNCTION switch for this appliance does NOT completely separate
it from the mains-power source. Additionally, the appliance consumes
power when in standby-mode. To completely separate the appliance
from mains-power, the power plug MUST be removed from the wall socket.
Information regarding the handling of batteries
The device and the remote control are operated by batteries. For the handling of
batteries please observe the following:
Risk of explosion!
Do not throw batteries into a fire. Do not recharge the batteries.
• Never open batteries, never solder or weld batteries.
The risk of explosions and injuries exists!
• Regularly check the condition of the batteries. Leaking batteries can
cause damage to the appliance.
• If you do not intend to use the appliance for an extended period, remove
the batteries.
• In the event of the batteries leaking acids, wear protective gloves.
• Clean the battery compartment and the battery contacts with a dry
cloth.
Attention!
No liability/warranty will be considered for damage to the DVD player
caused by the effects of moisture, water penetration or overheating!
7. Inserting batteries into the remote control
and DVD player
7.1. Inserting the Batteries into the Remote Control
1.
Open the battery compartment on the rear of the remote control.
2.
Place the two, supplied in the package, batteries type AAA/R03
(Micro cells) in the battery compartment. Make sure that the batteries
are inserted in accordance with the correct polarity.
3.
Replace the battery compartment cover.
Using the remote control
In order to guarantee faultless operation when using the remote control...
• Always point the remote control, during use, directely at the DVD player
• Make sure that there are no obstructions between the remote control
and the DVD player that will hinder reception
• When using the remote control place yourself not more than 5 metres
from the DVD player
Otherwise interferences can occur during operation of the DVD player functions
with the remote control.
7.2 Inserting the batteries into the DVD player
The DVD player can be operated by batteries. As soon as the DVD player is
connected to a power source via the power cable, power supply from the
batteries is switched off.
1.
Open the battery compartment on the underside of the DVD player.
2.
Now place 8 batteries type CR14/LR14 (Button cells) into the battery
compartment. Make sure that the batteries are inserted in accordance
with the correct polarity.
3.
Replace the battery compartment cover.
7.3. Replacing the batteries
If the operation of the DVD player via the remote control does not function
properly or does not function at all the batteries must be replaced
• Always renew all batteries in order to return the DVD player and the
remote control to their full performance ability.
- 4 -