Operation; Basic Operation; Volume; Bass/Treble/Balance/Fader - Silvercrest KH 2375 Operating Instructions Manual

Operation

Operation via the buttons on the
device and on the remote control
Most of the functions can be operated by the
buttons on the device as well as by the buttons
on the remote control. In these instructions the
buttons on the device are described.
If the buttons on the remote control are meant
this will be specifically mentioned.
Note
Approx. 5 seconds after a setting has been
made the playback will again be displayed
and the setting is saved.

Basic operation

Switching On and Off
POWER/DIM
Press briefly the
on. In the display the notice WELCOME appears.
POWER/DIM
• Briefly touch the
play illumination.
To switch off hold down the

Volume

• Turn the multi controller to increase or decrease
the volume.
Attention!
Always set the volume to a level that will allow
you, at any time, to clearly hear acoustical signals
from emergency service vehicles!

Bass/Treble/Balance/Fader

• Press the multi controller to display the current
settings for the Bass (BASS), Treble (TREBLE),
Balance (BALANCE) and Fader (FADER) .
• Turn the multi controller to change the settings.
button to switch the radio
button to dim the dis-
POWER/DIM
button longer.

Loudness

MD/LD
• Hold down the
function on or off.

Display

DISP
• By pressing the
in the display around in the following manner:
With radio reception:
Programme name, time of day (will automatically
be set with RDS reception), PTY settings (these RDS
functions are transmitted by the broardcast institu-
tions in various extents; see also the chapter "Radio
functions") and frequencies.
In CD mode:
Time of day, PTY settings and frequencies.
Note
If you do not receive any RDS or PTY information
"PS NONE" or "PTY NONE" appears in the dis-
play. Each notice only appears for a few seconds.

Setting the operating mode

MD/LD
• Press the
ception (frequency indicator), CD/MP3 operation
(CD), card slot (SD/MMC), USB port (USB) and
audio input (AUX).
Note
The operating modes CD, SD/MMC and USB
can only be accessed when the corresponding
medium is inserted.

RESET - Reset the radio

• To reset the car radio to its factory default settings
RESET
press the button with a pointed object, for
example a ball point pen.
• Reset the car radio:
- at initial operation,
- after the cable connection,
- if not all function buttons are working
- when an error message appears in the display.
- 10 -
button to switch the loudness
button you can switch the notices
button to switch between radio re-