External Cleaning; Cleaning The Cassette Unit; Cleaning The Cd Unit; Trouble-Shooting - E-Bench KH 2262 Operating And Safety Instructions Manual

Cd stereo radiorecorder
Table of Contents

Advertisement

8.1 External cleaning

• Clean all outside surfaces with a moist
but not wet cloth.
• Do not use any sort of aggressive clea-
ning fluids. These could damage the
external plastic housing.

8.2 Cleaning the cassette unit

This could be necessary if you notice the
tape sound becoming slightly muffled after
several weeks use. If you are sure the tape
is not the cause of this problem, ...
• Clean the tape heads and mechanism
with special tape cleaning materials
from specialist retailers - never use any
sort of tools. This could damage the devi-
ce.

8.3 Cleaning the CD unit

The CD player should not become dirty
from normal use! Cleaning may be neces-
sary if exceptionally dirty CDs are used, or
the CD tray is not closed and dust enters
the system.
Avoid dirt contamination by wiping dusty
CDs with a soft, dry cloth, wiping from the
inside to the outside of the CD.
If a CD cannot be played or sounds faulty
although it is in good condition ...
• Clean the lense and mechanism with a
cleaning CD from a specialist retailer -
never use any other sort of tool. This
could damage the device.

9. Trouble-shooting

If a thorough cleaning of the CD or tape unit
does not resolve the problem, it may not be
caused by dirt contamination, but could a
problem with the device.
• In this case, please return the device to
our customer service center.
If confusing symbols appear on the dis-
play, it is possible that the device's internal
operating system has "crashed".
• Disconnect the power cable and ...
• Remove the eight large batteries from
the battery compartment.
Wait a few minutes before restarting the
device. If no improvement should result
from this ...
• Repeat the two steps explained above
and ...
• Now also remove the three small batte-
ries from their compartment. This may
cause some or all preset radio stations to
be lost!
Wait a few minutes before restarting the
device. If the situation has not been resol-
ved by this measure, the device may be
faulty.
• In this case, please return the device to
our customer service center.
10

Advertisement

Table of Contents
loading

Table of Contents