Advertisement
Parts List
Screws (M3 x 6B)
................................................. 2
Screws (M3 x 6B)
................................................. 6
Mounting Plate A ...................................................... 1
Mounting Plate B ..................................................... 1
Mounting Plate C ..................................................... 1
Installation
1. Turn the transceiver's power off, and disconnect all cables from the transceiver.
2. Screw the mounting plate "A" to the FC-30 using the supplied screws (figure 1).
3. Remove the four rubber lugs and its four screws (figure 2), then screw the mounting plate "B" and "C" so that
its holes on the FT-897 using the supplied screws (figure 3).
4. To install the FC-30, position the FC-30 so that the mounting plate "A" on the side fit into the mounting plate
"B" on the FT-897 (figure 3), then screw the mounting plate "C" (on the FT-897) to the FC-30 using the
supplied screws (figure 1).
Do not install the supplied FC-30 Mounting Screws if you are not installing the FC-30! Also, do not use
an improper screw for mounting the FC-30! An improper screw may cause a "short circuit" to the
internal circuitry, causing serious damage!
Figure 1
Plate B
Installation of the "FC-30"
Plate A
Figure 3
Plate A
Plate B
Figure 2
Plate C
Plate C
Advertisement
