Resetting The System - Epson Runsense SF-710 User Manual

SF-710/510/310 User Manual

Resetting the System

If operations are unstable, try resetting the system.
Hold down all of the buttons (A/B/C/D) at the same time.
The screen is reset and the device restarts.
Initialise the device after restarting.
"Initial Settings" on page 26
U
c
Important:
Measurement data is not recorded if a system reset is performed while measuring.
Note:
❏ Setting data and measurement data remain as they were before the reset was performed.
❏ The following shows the differences between a system reset and initialisation. The time needs to be set again for both
operations.
System reset: The User Settings, Sys. Settings, Measure set., history, stride, heart rate monitor, and smartphone
registration information all remain as they were before the reset was performed.
Initialise: The User Settings, Sys. Settings, Measure set., history, stride, heart rate monitor, and smartphone
registration information are all Initialised.
Troubleshooting
138