Epson PowerLite 900 Quick Setup page 3

5
Replace the wireless LAN module stopper and secure it using the screw
you removed.
6
Close the air filter cover.
7
Plug in and turn on the projector.
8
To configure your projector for your wireless network, do one of
the following:
•
If you're using the optional Quick Wireless Connection USB key
(Windows only), insert it into the projector's USB TypeA port, wait
for the displayed message, remove the key, and connect it to a USB
port on your computer. Follow the on-screen instructions to install
the driver, then run your presentation. For details, see the User's
Guide on your projector CD.
•
If you're not using the key, continue with these steps.
9
Press the Menu button on the remote control, select the Network
menu, and press Enter.
10
Choose Network Configuration and press Enter.
11
Select the Basic menu and press Enter.
12
Select the Projector Name setting and enter a name (up to 16
characters long) to identify your projector over the network.
Use the displayed keyboard to enter characters. Press the arrow buttons
on the remote control to highlight the characters and press Enter to
select them.
Note: See the User's Guide on the projector CD for information on
adding passwords.
13
Select the Wireless LAN menu and press Enter.
14
Select the Connection Mode setting and choose one of these options:
•
Quick to connect the projector to one computer on the network
•
Advanced to connect the projector to multiple computers on
the network
15
If you selected Quick connection mode, select the Channel setting for
your wireless network and turn on the SSID Auto Setting setting.
16
Select the type of wireless network you are using as the Wireless LAN
Sys. setting.
17
If you selected Advanced connection mode, enter your network SSID (up
to 32 characters) as the SSID setting.
18
If your network assigns addresses automatically, select IP Settings and
turn on the DHCP setting. If not, turn off the DHCP setting and enter
the projector's IP Address, Subnet Mask, and Gateway Address,
as needed.
19
To prevent the SSID and IP address from appearing on the network
standby screen, set the SSID Display and/or IP Address Display settings
to Off.
20
When you are finished, select Complete and press Enter, then press
Enter again to save your settings.
21
Press the Menu button to exit the menu system.
22
See "Install network software" for additional instructions.
Install network software
Install the EasyMP ® Network Projection software to project wirelessly over
the network. Use the CD labeled Epson Projector Software for Meeting &
Presentation to install the program. Make sure to first install the optional Epson
802.11g/b/n wireless LAN module as described in "Project wirelessly".
For instructions on installing and using your network software, see the EasyMP
Network Projection Operation Guide on your projector CD. This guide is
installed along with your projector User's Guide.
To monitor and control your projector over the network, download and
install the EasyMP Monitor software and manual from the Epson support
website. You can install links to the download pages from your projector CD,
or go to www.epson.com/support and select your projector.