Read Me First - Panasonic CF-53 series Operating Instructions Manual

Read Me First

6. If trouble is experienced with this equipment, for repair
or warranty information, please contact Panasonic
Corporation of North America at DIAL TOLL FREE 1-
800-LAPTOP5 (1-800-527-8675). If the equipment is
causing harm to the telephone network, the telephone
company may request that you disconnect the equip-
ment until the problem is resolved.
7. There are no user serviceable parts contained in this
equipment.
8. This equipment may not be used on coin service pro-
vided by the telephone company. Connection to party
lines is subject to state tariffs.
9. The Telephone Consumer Protection Act of 1991
makes it unlawful for any person to use a computer or
other electronic device to send any message via a
telephone fax machine unless such message clearly
contains in a margin at the top or bottom of each trans-
mitted page or on the first page of the transmission,
the date and time it is sent and an identification of the
business or other entry, or other individual sending the
message and the telephone number of the sending
machine or such business, other entity, or individual. In
order to program this information into your fax soft-
ware, you should refer to the manual of the Fax soft-
ware being used.
10.According to the FCC's electrical safety advisory, we
recommend that you may install an AC surge arrestor
in the AC outlet to which this equipment is connected.
Telephone companies report that electrical surges, typ-
ically lightning transients, are very destructive to cus-
tomer terminal equipment connected to AC power
sources and that this is a major nationwide problem.
"Caution : To reduce the risk of fire, use only No.26 AWG or
larger (e.g., 24 AWG) UL listed or CSA certified telecommunica-
tion line cord."
FCC RF Exposure Warning:
This equipment is provided with external antenna connec-
tor(s) for connection to optional Car Mounter or Port Rep-
licator for mobile external mounted antenna(s). External
antenna(s) must be professionally installed and cannot
exceed recommended maximum antenna gain as
described in individual provided supplement instructions
for wireless transmitters. The Car Mounter is provided
with Radiall/Larsen WLAN whip antenna, type
NMO5E2400BKTNC with 5 dBi antenna gain. The maxi-
mum allowable antenna gain for the external WWAN base
whip antenna for the cellular band is 7.0 dBi and PCS
band is 3.5 dBi. Also, user must maintain minimum 20 cm
spacing between external antenna(s) and all person's
body (excluding extremities of hands, wrist and feet) dur-
ing wireless modes of operation.
USA Only: Disposal may be regulated in your community
due to Environmental considerations. For disposal or
recycling information, please visit Panasonic web site:
http://www.panasonic.com/environmental or call 1-888-
769-0149
6
Models for Canada
<Only for model with modem>
Industry Canada (IC) Notice for modem
This equipment contains an Industry Canada approved
modem unit.
The Industry Canada label is affixed on the modem unit.
EQUIPMENT ATTACHEMENT LIMITATIONS
"NOTICE: The Industry Canada label identifies certified
equipment.
This certification means that the equipment meets tele-
communications network protective, operational and
safety requirements as prescribed in the appropriate Ter-
minal Equipment Technical Requirements document(s).
The Department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment, users should ensure that
it is permissible to be connected to the facilities of the
local telecommunications company. The equipment must
also be installed using an acceptable method of connec-
tion. The customer should be aware that compliance with
the above conditions may not prevent degradation of ser-
vice in some situations.
Repairs to certified equipment should be coordinated by a
representative designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equip-
ment malfunctions, may give the telecommunications
company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the elec-
trical ground connections of the power utility, telephone
lines and internal metallic water pipe system, if present,
are connected together. This precaution may be particu-
larly important in rural areas. Caution: Users should not
attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or
electrician, as appropriate."
16-M-1
"NOTICE: The Ringer Equivalence Number (REN)
assigned to each terminal device provides an indication of
the maximum number of terminals allowed to be con-
nected to a telephone interface.
The termination on an interface may consist of any combi-
nation of devices subject only to the requirement that the
sum of the Ringer Equivalence Numbers of all the devices
does not exceed 5."
REN: See bottom of the computer
Canadian ICES-003
This Class B digital apparatus complies with Canadian
ICES-003.
<Only for model with wireless LAN/Bluetooth/wireless
WAN/GPS>
Industry Canada
32-M-1
This product complies with RSS210 Industry Canada.
Operation is subject to the following two conditions;
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
65-M-2
17-Ca-1
7-M-2
30-Ca-1-1