Panasonic U-36LE1U6 Service Manual page 60

1. Outdoor Unit Maintenance Remote Controller
Setting mode 2
Press the
button and the
4 seconds or longer.
Press the temperature setting
buttons to change the item code. The item codes
and setting data are shown in the table below.
Press the timer time
change the setting data.
To confirm the changed setting data, press the
(SET) button.
(At this time, "
" " blinks when this mode is engaged, and
when this mode is engaged, "Now Setting" is dis-
played blinking, and the address of the outdoor
unit that is being set "System XX-YY" (System XX
= System address, YY = Outdoor unit address),
the item code No. (values from the table below),
and the corresponding settings data (8 digits) are
displayed. The item code number (values shown
in the table below) and the corresponding setting
data (8 digits) are also displayed. (The 8 digits of
the setting data are displayed by changing
between the first 4 digits (Fig. (C)) and the last
4 digits (Fig. (D)). When the first 4 digits are
displayed, the bottom dot of the colon is lit.)
To exit setting mode, press the
button. Returns to normal display mode.
6
CODE
Parameter
NO.
Outdoor unit capacity 0 = Disabled
(CHECK) button, (SET)
(CANCEL) button simultaneously for
and
and buttons to
" stops blinking and remains lit.)
(CHECK)
224 (70 Type)
4
5
(C) Display of first 4 digits
(D) Display of last 4 digits
Refrigerant type : (C) and (D) are displayed alternately.
The example here (0000, 0410) indicates R410A.
Description (SET DATA)
80 (25 Type) 112 (36 Type)
280 (90 Type) 355 (115 Type) 400 (130 Type) 450 (140 Type)
6 - 10
Service Checker
3
1
140 (48 Type) 160 (52 Type)
2