Charging The Battery Pack - Sony Cyber-shot DSC-HX200 Instruction Manual

Charging the battery pack

DC IN jack
Power cord
(Mains lead)
AC Adaptor
1
Connect the DC IN jack of the camera and the AC
Adaptor (supplied). Plug the AC Adaptor into the wall
outlet (socket) using the power cord (mains lead)
(supplied).
The Power/Charge lamp lights orange, and charging starts.
• Turn off the camera while charging the battery.
• You can charge the battery pack even when it is partially charged.
• When the Power/Charge lamp flashes and charging is not finished,
remove and re-insert the battery pack.
Notes
• If the Power/Charge lamp on the camera flashes when the AC Adaptor is
connected to the wall outlet (wall socket), this indicates that charging is
temporarily stopped because the temperature is outside the recommended range.
When the temperature gets back within the appropriate range, the charging
resumes. We recommend charging the battery pack in an ambient temperature of
between 10°C to 30°C (50ºF to 86ºF).
• The battery pack may not be effectively charged if the terminal section of the
battery is dirty. In this case, wipe any dust off lightly using a soft cloth or a cotton
swab to clean the terminal section of the battery.
• Connect the AC Adaptor (supplied) to the nearest wall outlet (wall socket). If any
malfunctions occur while using the AC Adaptor, disconnect the plug from the wall
outlet (wall socket) immediately to disconnect the power source.
Power/Charge lamp
Lit: Charging
Off: Charging finished
Flashing: Charging error
Align v marks.
Charging paused due to
overheating
GB
GB
15