Cannot Print Over A Netware Network - Canon imagePROGRAF iPF6000S User Manual

Cannot print over a TCP/IP network
The printer's IP address is not congured correctly.
The printer's TCP/IP network settings are not
congured correctly.
The computer you are trying to print from is not
congured correctly.

Cannot print over a NetWare network

The printer's NetWare settings are not congured
correctly.
The computer you are trying to print from is not
congured correctly.
The NetWare server and services are not congured
correctly.
The printer was turned off and on when not
disconnected from the server.
Downloaded from ManualsPrinter.com Manuals
Cause
Cause
Corrective Action
Make sure the printer's IP address is congured
correctly.
(→P.432)
(→P.470)
Make sure the printer's TCP/IP network settings are
congured correctly.
(→P.473)
Make sure the computer's TCP/IP network settings
are congured correctly.
(→P.481)
(→P.501)
Corrective Action
Make sure the printer's NetWare settings are
congured correctly. In particular, make sure a valid
frame type is selected. For details, see "Conguring
the Printer's NetWare Network Settings". (→P.476)
Make sure the computer's NetWare settings are
congured correctly. For details, see "Conguring
NetWare Network Settings". (→P.493)
Check the following points.
1.
Make sure the NetWare le server is running.
2.
Make sure there is enough free disk space on the
NetWare le server. Insufcient disk space may
prevent you from processing large print jobs.
3.
Start NWADMIN or PCONSOLE and conrm that
the print service is congured correctly and the
print queue is available.
4.
If data transmission to a printer on another subnet
fails, deactivate NCP burst mode in that printer's
network protocol settings.
5.
If the printer is used in queue server mode, specify
"Other/Unknown" as the printer type.
Leave the printer off for at least 30 seconds, and
then restore power.
Cannot print over a network
Troubleshooting 675