Table of Contents
Advertisement
Notice:
The changes or modifications not
expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
IMPORTANT NOTE:
To comply with the FCC RF exposure
compliance requirements, no change to
the antenna or the device is permitted.
Any change to the antenna or the device
could result in the device exceeding the
RF exposure requirements and void
user's authority to operate the device.
This equipment complies with FCC radiation exposure
limits set forth for uncontrolled equipment and meets the
FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65. This equipment has very low
levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it
is desirable that it should be installed and operated with
at least 20 cm and more between the radiator and
person's body (excluding extremities: hands, wrists, feet
and legs).
NOTICE
This equipment has been tasted and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
¡ Reorient or relocate the receiving antenna
¡ Increase the separation between the equipment and
receiver.
¡ Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
¡ Consult the dealer or an experienced radio/ TV
technician for help.
This transmitter must not be co-located or
operated in conjunction with any other
antenna or transmitter.
5
Advertisement
Table of Contents
