Husqvarna C42C 954 04 05-09 Owner's Manual page 10

For Parts Call K&T 606-678-9623 or 606-561-4983
7
CHUTE LATCH ASSEMBLY
(See Fig. 7)
Use Hardware - - GROUP "E & F"
1. Assemble latch pin to upper chute, as shown.
2. Press weld nut into rubber latch and assemble rubber
latch to lower chute, as shown.
3. Tighten all hardware securely.
SCREW
#10 x 1-1/8"
UPPER CHUTE
SCREW
#10 x 5/8"
LOWER CHUTE
WASHER
3/16 x 3/4 x 16 Ga.
FIG. 7
8
CONTAINER MOUNTING (See Fig. 8)
No hardware required
1. Install one container to left side fi rst with warning to
outside of unit. Install other container to right side.
NOTE: Right con tain er should always over lap left con tain er
at center sup port.
2. Close cover and lock latch handle over center support
tube.
COVER LATCH
HANDLE
CONTAINER
WARNING
R A W
N N I
G
CONTAINER
HANDLE
mow
rate r and
not to wea ope age
Do ject or dam
sub ked
crac
FIG. 8
WASHERS
3/16 x 3/4 x 16 Ga.
SPLIT
SPACER
ACORN NUT
RUBBER
LATCH
WELD
NUT
LOCK WASHER
CENTER
SUPPORT
TUBE
whe n
lace tain er.
per lyis tly. Rep t con
is pro freq uen lace men
tain er bag ed rep
ss con n. Che end ck
er unle ratio a reco mm
deti erio only
d. Use
CONTAINER
WARNING
www.mymowerparts.com
9
UPPER CHUTE (See Fig. 9A & 9B)
No hardware required
1. Lower mower deck to its lowest cutting position.
2. Assemble upper chute by inserting curved end into
hole in back of cover.
NOTE: Handle carefully so as not to damage dump bag
in di ca tor.
3. Push in and turn upper chute until it is in line with lower
chute.
4. Align the bosses on lower chute with alignment slots
on upper chute and slide together.
5. Secure with rubber latch by hooking hole in latch over
latch pin.
UPPER
CHUTE
COVER
10
LEVEL MOWER DECK
Be sure deck is properly leveled for best mower per for mance.
See your tractors owner's manual for in struc tions.
10
DUMP BAG
INDICATOR
HANDLE
LOWER
CHUTE
FIG. 9A
ALIGNMENT
SLOT
LATCH PIN
RUBBER
LATCH
BOSSES
FIG. 9B