GE WDSS4120 Owner's Manual page 14

Before you call for service...
Troubleshooting Tips
NOISE
Washer is noisy
OTHER
Labels on the exterior
of the washer will not
peel off cleanly
14
Possible Causes
Washer is uneven
Washer load is
unbalanced
Shipping plug is still assembled
in unit
Washer is sitting too close
to wall (causes knocking
during cycle)
Possible Causes
Occasionally the adhesive
used on the labels does
not release cleanly
What To Do
• To level the front of the washer, adjust the front leveling
legs by rotating the individual leg in the proper direction
for up or down. To level back of washer, lift back of
machine 4" (11 cm) and set down.
• Push the Cycle knob in to stop the washer, open the lid
and redistribute the load evenly. Close the lid and restart.
• See Installation Instructions for details on removing
shipping plug.
• Pull washer away from the wall; about 4" (11 cm)
is needed.
What To Do
• Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the surface
of the washer.