Transmission Assembly - Yamaha 2010 YZF-R6 Manual Instruction

Transmission Assembly

The seal side should face outward (one side
seal bearing) and press in the bearing cup all
the way into the case until it touches bottom.
Points to be careful of the oil seal assembly
The convex part on the oil seal should be
put into the case groove vertically so that
the oil seal does not fall over and is tightly
fit into the bearing cup of the bearing.
(Apply grease to the lip.)
Matching mark
Matching mark
Washer
Washer
Shaft
Edge
Detail of installation of washer
Matching mark
Matching mark
Washer
Washer
Shaft
Edge Portion R
Detail of installation of washer
TIP
• Always use a new circlip.
• Do not mistake the washer and circlip directions.
(See drawing below.)
Portion R
Rotate washer so that its teeth meet axle-
spline teeth on the axle, and then lock with
washer s claw.
Assemble washer with putting together
their matching mark.
– 26 –
Apply molybdenum oil to inside of diameter.
After assembly, it should rotate smoothly.
Apply molybdenum oil to the inside diameter
and end. After assembly, it should rotate
smoothly.
Apply molybdenum oil to teeth of spline.
After assembly, it should slide smoothly.
Washer
Circlip
Gear
Shaft
Edge Portion R
Position the abutment joint of the circlip
right between the splines.
Detail of installation of circlip
Washer
Circlip
(Direction
not applicable)
Gear
Shaft
Position the abutment joint of the
circlip right between the splines.
Detail of installation of circlip