Connecting Peripheral Devices - Fujitsu Primergy RX100 S5 Start Manual

Hide thumbs Also See for Primergy RX100 S5:

Table of Contents

Install the server in the rack.

��

Insert the inner rails attached to the server

straight on the grooves in the slide rails.

Do not push the inner rails into the slide rails by

force. Fittings of the inner rails may be trans-

formed, and the rails do not move normally.

Release the locks on both sides of the inner

rails (press up for the right side and press

down for the left side), and slide the server

backward slowly to install it in the rack.

Connecting peripheral devices

Peripheral devices, such as the keyboard and mouse, etc., are connected to the server in the following

order.

�

- The external USB options can be connected to the front USB connectors of the server.

- Connect cables with enough allowance for operation while the device is pulled out from the rack.

n Securing the power cable with the release tie

After connecting the power cable to the server, secure the power cable with the provided beaded tie and release tie to the rear

of the server, to prevent the cable from unplugging when the server is pulled forward and out.

When unplugging the cable, make sure to unplug the connector on the server end.

��

�

��

Be careful not to pinch your fingers or catch any cloth-

ing when sliding the server into the cabinet. This could

cause injury.

Secure the server to the rack.

Install the attached blank panel to the rack, where the serv-

er or peripheral devices are not installed.

��

�

��

Table of Contents