Download
Share
Print this page
Baja motorsports RT50-R Setup Instructions
  1. Manuals
  2. Brands
  3. Baja motorsports Manuals
  4. Scooter
  5. RT50-R Retro
  6. Setup instructions
Baja motorsports RT50-R Setup Instructions

Baja motorsports RT50-R Setup Instructions

Retro scooter
Hide thumbs Also See for RT50-R:

Advertisement

Quick Links

Download this manual See also: Owner's Manual
RT50-R Retro Scooter Set up Instructions
Removal from Crate
1. Remove cardboard carton
from metal frame.
2. Remove scooter and parts provided
for assembly from carton.

Advertisement

loading

Related Manuals for Baja motorsports RT50-R

Summary of Contents for Baja motorsports RT50-R

  • Page 1 RT50-R Retro Scooter Set up Instructions Removal from Crate 1. Remove cardboard carton from metal frame. 2. Remove scooter and parts provided for assembly from carton.

  • Page 2: Parts And Hardware

    Parts and Hardware Rear View Mirrors Tools Zip ties Headlight panel Steering column hardware hardware Headlight Panel Battery Front Wheel...
  • Page 3 Handlebar Handlebar Steering stem assembly Bolt 3. Attach handlebar assembly to steering stem using hardware provided. Torque bolt to 33 ft.lbs. Zip tie Electrical components 4. Connect electrical components and secure all wires with zip tie.

  • Page 4: Front Wheel

    Front wheel Alignment tab on front fork Axle bolt Speed sensor 5. Align speed sensor between front wheel and front fork. Front wheel 6. Place front wheel spacer between disc spacer brake and fork on axle bolt. Attach front wheel with axle nut provided. Torque to 33ft.lbs.
  • Page 5 Headlight Panel Headlight panel 9. Connect headlight wire. 10. Insert headlight panel to tabs on scooter and secure with 4mm phillip head screws.
  • Page 6 Mirrors 11. Attach left and right mirrors to handlebars secure by tightening nut. Rear Mud Flap Mud flap 12. Attach rear mud flap to rear fender with 4mm phillip head screw.

  • Page 7: Battery Installation

    Battery Installation Battery located in floorboard. WARNING The following procedure is very dangerous and should be performed with utmost care and attention. Wear protective eyewear, rubber gloves, and have water available should electrolyte come in contact with skin or eyes. KEEP ALL CHILDREN AWAY FROM THE AREA WHILE THIS PROCEDURE IS BEING PERFORMED. POISON –...
  • Page 8 Battery Installation Note: The following page is for vehicles with battery’s containing separate electrolyte pack. Most battery’s will come with the electrolyte already sealed into the battery. Preparing the battery: · Place battery on level surface. Remove sealing tape from top. (see figure 20) ·...
  • Page 9 Battery Installation How to Initially Charge the battery: 1. Connect the red positive (+) cable to the red positive (+) pole of the battery. (see figure 23) 2. Connect the black negative (-) cable to the black negative (-) pole of the battery. (see figure 24) Figure 23 Note: The red positive (+) cable has a larger diameter than the black negative (-) cable.
  • Page 10 Gas and Oil 13. Fill engine with correct amount of oil. Refer to owners manual for oil types and quantity. 14. Fill gas tank as specified in owners manual. Fuel tank located under seat Oil Plug. !!WARNING!! This engine may be shipped with packing oil.