Asus Z10PR-D16 User Manual page 152

Red Hat Enterprise Linux OS 5.6
®
To install the LSI MegaRAID controller driver when installing Red Hat
1. Boot the system from the Red Hat
At the boot:, type linux dd noprobe=ata1 noprobe=ata2..., then press
2.
<Enter>.
The number of ata varies with the hard disk drive number you have when building a RAID
set. For example, if you want to build a RAID set with 6 hard disk drives, type command
line: linux dd noprobe=ata1 noprobe=ata2 noprobe=ata3 noprobe=ata4 noprobe=ata5
noprobe=ata6.
- To install or upgrade in graphical mode, press the <ENTER> key.
- To install or upgrade in text mode, type: linux text <ENTER>.
- Use the function keys listed below for more information.
[F1-Main] [F2-Options] [F3-General] [F4-Kernel] [F5-Rescue]
boot: linux dd noprobe=ata1 noprobe=ata2
3. Select Yes using the <Tab> key when asked if you have the driver disk, then press
<Enter>.
Do you have a driver disk?
Yes
4. Insert the Red Hat
OK, then press <Enter>.
Insert your driver disk into /dev/fd0
and press "OK" to continue.
The drivers for the RAID card are installed to the system.
6-6
®
Main Menu
No
Enterprise RAID driver disk to the USB floppy disk drive, select
®
Insert Driver Disk
OK Back
OS installation CD.
Enterprise OS:
®
Chapter 6: Driver installation