Panasonic KX-TG2583CB Operating Instructions Manual page 82

Before Requesting Help
General
Problem
The unit does not work.
You cannot program items,
such as the dialing mode.
Previously programmed
information is erased.
"Recharge battery" is
displayed on the handset,
" " flashes or the unit
beeps intermittently.
You charged the battery
fully, but "Recharge
battery" is still displayed
and/or "
flash.
The IN USE/CHARGE
indicator light does not go
out while charging.
82
" continues to
Remedy
•Check the settings (p. 10–15).
•Charge the battery fully (p. 11).
•Clean the charge contacts and charge
again (p. 12).
•Install the battery properly (p. 75).
•Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in,
and try again.
•Re-install the battery and place the
handset on the base unit (p. 75). Try
again.
•Programming is not possible while the
unit is in the talk or speakerphone mode,
when viewing the Caller List/directory
list, or while the answering system is in
use.
•Do not pause for over 60 seconds while
programming.
•Move closer to the base unit.
•Make sure that the unit is in the standby
mode.
•If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
•Charge the battery fully (p. 11).
•Clean the charge contacts and charge
again (p. 12).
•Install a new battery (p. 75).
•This is normal.