Using With Your Pc - Panasonic Lumix DMC-TZ4 Operating Instructions Manual

r
Connecting
with other
devices
\..
Using with your PC
SET.
SELECT:
mUSBMODE
Turn on power of
both camera and
computer
Set REC/PLAY
switch to
(B
Connect camera to
computer
Select 'PC' on the
camera
(A message may be displayed
on screen if 'USB MODE' (P.25)
is set to 'PictBridge (PTP)'.
Select 'CANCEL' to close the
screen, and set 'USB MODE'
to 'PC'.)
Operate with you r
computer
(see next
page)
2
3
5
1
USB connection cable
• always use cable
supplied
Click 'Safely Remove Hardware' in the Windows
System Tray ---.. disconnect USB connection cable ---..
turn off camera power ---.. disconnect AC adaptor
0
0
If using AC adaptor, turn
off camera power before
plugging in or removing.
Connect the camera to your computer to save, play,
print, and e-mail your pictures.
Set-up:
• Connect the camera to the AC adaptor (DMW-
AC5PP, sold separately). (Alternatively, use a
sufficiently-charged battery.)
• Card :Insert card and set mode dial to
any except
Gr
Built-in memory :Remove card
Hold here
(Push until it is fully
inserted.)
ACCESS
(sending data)
• Do not disconnect the USB
connection cable while
'ACCESS' is displayed.
.To cancel connection
~~~f~~E~~~~~i~~~~~;~~i~~~:~::i~r~~:~::::::::ng
f o r
fir~~~~'
I
;"!r
When the battery begins to run out during communication, the status indicator flashes
and a warning beep sounds. Cancel communication via your computer immediately
(recharge the battery before reconnecting).
Setting the 'USB MODE' (P.25) to 'PC' remove the need to make the setting each time
the camera is connected to the computer.
For more details, consult your computer operating manual.
VQT1P79
81