If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) Your Black & Decker drill/screwdriver has been designed for protected supply. Use of an RCD reduces the risk of screwdriving applications and for drilling in wood, metal and electric shock.
Page 5
Hold power tool by insulated gripping surfaces when e. Maintain power tools. Check for misalignment or performing an operation where the cutting accessory binding of moving parts, breakage of parts and any may contact hidden wiring or its own cord. Cutting other condition that may affect the power tools accessory contacting a "live"...
Fitting and removing a drill bit or screwdriver bit (fig. B) This tool uses screwdriver bits and drill bits with a 1/4" (6.35 mm) The charger is intended for indoor use only. hexagonal shank. Pull back the bit holder sleeve (5).
Set the collar (4) to the lowest torque setting. amount of washing liquid or soap as a lubricant. Tighten the first screw. Always hold the tool and screwdriver bit in a straight line If the clutch ratchets before the desired result is achieved, with the screw.
Alternatively, a list of authorised Black & Decker repair agents and full details of our This tool uses screwdriver bits and drill bits with a 1/4" (6.35 mm) after-sales service and contacts are available on the Internet hexagonal shank.
EC declaration of conformity Alternatively, a list of authorised Black & Decker repair agents and full details of our after-sales service and contacts are HP9060 available on the Internet at: www.2helpU.com Black & Decker declares that these products conform to: 98/37/EC, EN 60745 Please visit our website www.blackanddecker.co.uk to register your new Black &...
Page 12
Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, Fax 03-9727 5940 Victoria, 3138 New Zealand Black & Decker Tel. +64 9 259 1133 5 Te Apunga Place Fax +64 9 259 1122 Mt Wellington Auckland 1060 United Kingdom Black &...