Clock - GMC Savana 2011 Owner's Manual

Hide thumbs Also See for Savana 2011:
Table of Contents

Advertisement

5-6
Instruments and Controls
If the DIC display does not show a
heading, for example, N for North,
or the heading does not change
after making turns, there may be a
strong magnetic field interfering with
the compass. Such interference
may be caused by a magnetic CB
or cell phone antenna mount, a
magnetic emergency light, magnetic
note pad holder, or any other
magnetic item. Turn off the vehicle,
move the magnetic item, then turn
on the vehicle and calibrate the
compass.
To calibrate the compass, use the
following procedure:
Compass Calibration Procedure
1. Before calibrating the compass,
make sure the compass zone
is set to the variance zone in
which the vehicle is located.
See Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration procedure.
2. Press
until PRESS
CALIBRATE COMPASS
displays.
3. Press
to start the compass
calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle
in tight circles at less than
8 km/h (5 mph) to complete
the calibration. The DIC
will display CALIBRATION
COMPLETE for a few seconds
when the calibration is complete.
The DIC display will then return
to PRESS
TO CALIBRATE
COMPASS.
I n f o r ma t i o n P r o v i d e d b y :

Clock

AM/FM Radio with Optional
CD Player
If the vehicle has an AM/FM radio
TO
with an optional CD player, it has
a
button for setting the time. With
these types of radios, the clock can
be set with either the radio turned
on or off.
Set the time by following these
steps:
1. Press
until the hour begins
flashing on display. Press this
button a second time and the
minutes begin flashing on
display.
Press
a third time and the
12HR or 24HR time format
begins flashing.

Advertisement

Table of Contents
loading

Table of Contents