Disabling A Forgotten Password; Baseboard Management Controller Configuration - Dell PowerEdge T605 Systems Hardware Owner's Manual

If you do not enter the correct password in three attempts, the system lets you
view, but not modify, the System Setup screens—with the following
exception: If System Password is not set to Enabled and is not locked through
the Password Status option, you can assign a system password, but you cannot
disable or change an existing system password).
NOTE:
You can use the Password Status option in conjunction with the Setup
Password option to protect the system password from unauthorized changes.
Deleting or Changing an Existing Setup Password
1 Enter the System Setup program and select the System Security option.
2 Highlight the Setup Password option, press <Enter> to access the setup
password window, and press <Enter> twice to clear the existing setup
password.
The setting changes to Not Enabled.
3 If you want to assign a new setup password, perform the steps in "Assigning
a Setup Password" on page 59.

Disabling a Forgotten Password

See "Disabling a Forgotten Password" on page 203.

Baseboard Management Controller Configuration

The Baseboard Management Controller (BMC) enables configuring,
monitoring, and recovery of systems remotely. BMC provides the following
features:
• Uses the system's integrated NIC
• Enables fault logging and SNMP alerting
• Provides access to system event log and sensor status
• Allows control of system functions including power on and off
• Functions independently of the system's power state or the system's
operating system
60
Using the System Setup Program