Peripherals - Gigabyte G1.Sniper B6 User Manual

& User Password
Allows you to configure a user password. Press <Enter> on this item, type the password, and then press
<Enter>. You will be requested to confirm the password. Type the password again and press <Enter>.
You must enter the administrator password (or user password) at system startup and when entering BIOS
Setup. However, the user password only allows you to make changes to certain BIOS settings but not all.
To cancel the password, press <Enter> on the password item and when requested for the password, enter
the correct one first. When prompted for a new password, press <Enter> without entering any password.
Press <Enter> again when prompted to confirm.
NOTE: Before setting the User Password, be sure to set the Administrator Password first.
2-5

Peripherals

& Initial Display Output
Specifies the first initiation of the monitor display from the installed PCI graphics card, PCI Express graphics
card or the onboard graphics.
IGFX Sets the onboard graphics as the first display.
Sets the graphics card on the PCIEX16 slot as the first display. (Default)
PCIe 1 Slot
Sets the graphics card on the PCIEX4 slot as the first display.
PCIe 2 Slot
PCI Sets the graphics card on the PCI slot as the first display.
& Audio LED
Enables or disables the onboard audio LED function.
Disables this function.
Off
Still Mode The LED stays constantly on. (Default)
Beat Mode The brightness of the LED changes according to the music rhythm.
Pulse Mode The brightness of the LED changes slowly and smoothly like breath.
& PCH LAN Controller
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
- 29 -