Adjusting The Monitor Settings; Using The On-Screen Display Menu - HP LCD Monitor Reference Manual

To use the auto-adjustment feature:
1. Allow the monitor to warm up for 20 minutes before adjusting.
2. Press the
●
You can also press the
the OSD Main Menu. Refer to
●
If the result is not satisfactory, continue with the procedure.
3. Insert the CD in the disc drive. The CD menu is displayed.
4. Select Open Auto-Adjustment Software. The setup test pattern is displayed.
5. Press the
6. Press the
Figure 3-1
NOTE: The auto-adjustment test pattern utility can be downloaded from http://www.hp.com/support.

Adjusting the Monitor Settings

The monitor settings can be adjusted from the On-Screen Display (OSD) menu.
NOTE: If there is a problem with the display settings, try resetting the settings to the factory defaults
by opening the OSD and selecting Factory Reset from the OSD menu.

Using the On-Screen Display Menu

Use the On-Screen Display (OSD) to adjust the screen image based on your viewing preferences. To
access the OSD, do the following:
1. If the monitor is not already on, press the
2. To access the OSD Menu, press the
3. To navigate through the OSD Menu, press the
scroll up, or the
4. To select an item from the OSD Menu, use the
selection, then press the
your model).
ENWW
auto button on the monitor front panel.
Menu
auto button on the monitor front panel to produce a stable, centered image.
ESC key or any other key on the keyboard to exit the test pattern.
Auto-Adjustment Test Pattern
– (Minus) button to scroll in reverse.
OK button to select that function (the
button, then select Image Control > Auto-Adjustment from
Adjusting the Monitor Settings on page 7
Power button to turn on the monitor.
Menu button on the monitor's front panel.
+ (Plus) button on the monitor's front panel to
+ or – buttons to scroll to and highlight your
in this chapter.
OK button may be different on
Using and Adjusting the Monitor 7